Fast setting cyanoacrylic acid ester based adhesive. Supa Glue dries colourless.
Features:
- Bonds to a variety of surfaces
- Quick setting
- Dries clear – no mess
- No mixing required
- No clamping necessary
- Heat resistant – approx 80°C maximum
- Non toxic when set
- Water-resistant
- Application range: -55°C to +75°C
Where can this product be used?
- All types of small household repairs
What materials is this product suitable for?
- Metal
- Rubber
- China
- Wood
- Most plastics*
*Not recommended for use on paper, leather, polyethylene or Teflon.
Directions of use:
1. Carefully pierce seal at end of metal tube with reverse end of cap. Replace plastic nozzle.
2. Surfaces to be bonded should fit exactly and should be clean, dry and free from dust, dirt and grease.
3. Apply a drop of Supa Glue to only one of the surfaces to be bonded. Use sparingly. Do not spread. (Note: 1 drop covers an area of 25mm x 25mm.)
4. Quickly align both surfaces. Keep fingers away from any excess adhesive so they will not get stuck. Apply slight pressure to ensure effective spreading and bonding. Should you fail to align the surfaces correctly, do not attempt to re-align them and bond together again. Keep apart and completely clean the surfaces (with acetone or nail polish remover). When dry, re-apply adhesive, re-align and bond again.
5. Allow several minutes to provide sufficient bond strength for practical use. Maximum strength is achieved after 12 hours.
6. Wipe tip of tube with a cloth or paper and replace cap.
Limitations:
- Not suitable for bonding plastics such as Polypropylene and Polyethylene.
- Water resistant not water proof, therefore not suitable for surfaces that will be continually wet.
- Not flexible and has low impact resistance.
- Not suitable for repairing items that are in direct contact with hot liquids – eg. saucepans or repairing handles of vessels which contain hot liquids.
- Will not permanently bond glass or materials containing alkaline elements.
- Has no gap filling properties therefore surfaces need to be a close fit.
- Not recommended for highly porous surfaces.
- Not recommended for paper or leather.